How To Tie The Belt
Return To Menu  

by
Grand Master James S. Benko, Ph.D.


How To Tie The Belt
-1-
Place the belt in front of your body, short section of the belt to your right.
-2-
With your left hand, pass the belt around the back of your waist making sure you bring it over the top of the belt in front.
-3-
Belt should look like this after first pass around your waist.

-4-
With your left hand, again pass the belt around the back of your waist making sure you bring it over the top of the belt in front.
-5-
Belt should look like this after second pass around your waist.
-6-
(Intermediate Position)

-7-
Pass the portion of the belt you just wrapped around your waist under and behind the belt in the front of your waist pulling it upward.
-8-
Cross your left hand over your right hand so that the belt is crossed. Then change your hands to hold opposite ends of the belt.
-9-
Bring the lower portion of the belt up and place it through the loop created by the crossing of the belts.

-10-
Grab the ends of the belt, one in each hand.
-11-
Pull both ends of the belt to tighten it.
-12-
The length of the belt ends should be equal.


ITA Home Page       Top of Page  


Copyright 1998-2012 James S. Benko and ITA Institute.
All rights reserved.